How to Use
FEATURE DETAIL
How to UseScanning Range Finder
Turn on the LiDAR
Preparation (DC power supply)
Since the LiDAR is a DC power supply specification, it will break down if it is directly connected to an outlet.
Prepare a DC power supply such as a switching power supply, AC-DC converter, or AC adapter.
Preparation (wiring)
The LiDAR is delivered with our inspection connector attached.
This connector cannot be used as an extension connector. Please cut it off if necessary and attach any connector.
Turn on the power
The DC power supply has a polarity unlike the AC power supply.
Confirm "+" and "-" carefully, and then turn on the power after connecting to the DC power supply.
Start confirmation
The LiDAR is equipped with a power indicator.
You can check whether the sensor has been activated correctly by the behavior of the indicator light. The behavior of the indicator light is depending on the sensor.
Product's Category
- Scanning Rangefinder
- Photoelectric Switch
- Sensor for Iron & Steel Industry
- Optical Data Transmission Device