Malfunction output

The failure output (FAULT) determines the failure of the light receiving part (receiver) as well as the light emitting part (transmitter) and outputs when one of them are failure.
* However, the waveguide type of micromaster monitors only the operation of the transmitter.

Installed model	Indicator light	Output operation
KRG series	It will light when the light emitting or receiving circuit is abnormal	□ OUT4 Normal: CLOSE Abnormal: OPEN
KAD series	Projector: It will light when the amount of light emitted is 2/3 or less of the initial value Receiver: It will falsh when the amount of light received is 1/5 or less of the initial value continuously (about 3 seconds).	□ Terminal number 9-10 Normal: CLOSE Abnormal: OPEN □ Terminal number 10-11 Normal: OPEN Abnormal: CLOSE
MBX-211	Transmitter failure indicator: It will light when the light emitting circuit is abnormal Receiver failure indicator: It will light when the light receiving circuit is abnormal Note) If the transmitter fails at the same time, the receiver failure indicator will not light up.	□ Terminal number 9-10 Normal: OPEN Abnormal: CLOSE □ Terminal number 10-11 Normal: CLOSE Abnormal: OPEN
MBX-301	Failure indicator: It will light when a transmission failure occurs.	□ Terminal number 9-10 Normal: OPEN Abnormal: CLOSE □ Terminal number 10-11 Normal: CLOSE Abnormal: OPEN
VMH series	RUN: It will light when the internal CPU stops or runs out of control.	□ RUN Normal: CLOSE Abnormal: OPEN
PRP series	Main unit display E1: Motor failure E2: Shutter motor failure E3: Sensor internal temperature abnormality	D-SUB 15 pin □ Pin number 11-12 Normal: OPEN Abnormal: CLOSE □Pin number 13-14 Normal: CLOSE Abnormal: OPEN Terminal block □ Terminal number 7-8 Normal: OPEN Abnormal : CLOSE □ Terminal number 8-9 Normal: CLOSE Abnormal: OPEN